Viper 160XVL - Manual (Page 22)

19
© 2006 Directed Electronics—all rights reserved
Rapid Resume Logic
This Directed Electronics system will store its current state to non-
volatile memory. If power is lost and then reconnected the system
will recall the stored state from memory. This means if the unit is
in Valet Mode and the battery is disconnected for any reason, such
as servicing the car, when the battery is reconnected the unit will
still be in Valet Mode. This applies to all states of the system
including arm, disarm, and Valet Mode.
Programming Options
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some may
require additional installation labor. This system's programming
options are listed below, with the factory default settings in bold:
■ 12, 24, or 60 minute run time. your system can be pro-
grammed to allow the vehicle to run for 12, 24, or 60 min-
utes when remote started.
■ 3, 6, 9, or 12 minute timer mode run time. Your system can
be programmed to allow the vehicle to run for 3, 6, 9, or 12
minutes when remote started in timer mode. Can be set up to
16 minutes by your installer.