Viper 160XVL - Manual (Page 28)

25
© 2006 Directed Electronics—all rights reserved
Quick Reference Guide
To arm using your remote
■ To arm the system press
for one second. The doors will lock (if con-
nected). The LED will begin to flash. The vehicle’s horn (if connected)
will honk and the parking lights will flash once to confirm arming.
To disarm using your remote
■ To disarm the system press
for one second. The doors will unlock (if
connected). The vehicle’s horn (if connected) will honk twice and the
parking lights will flash twice.
Disabling the Failsafe ® Starter Kill without a transmitter
■ Turn on the ignition. Press and release the Valet button within 10 sec-
onds. The LED will stop flashing and the vehicle should start.
To remote start the vehicle
■ Press
twice within 3 seconds. The parking lights will turn on (if con-
nected) and the vehicle will start and run for the programmed duration.
To enter or exit Valet Mode
■ Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet button within 10 seconds. The status LED will light
steadily if you have entered Valet Mode. To exit Valet Mode, repeat the
steps above. The LED will turn off when exiting Valet Mode.
To activate Panic Mode
■ Press and hold
for 1.5 seconds.
To activate Timer Mode
■ Press
and to start the vehicle, and run it for the set duration.
To activate Turbo Mode
■ Park the vehicle and set parking brake. Remove your foot from the brake pedal
and leave the engine running. Press and release the and buttons.
To disable the remote start system
■ To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________
Cut along dotted line and f
old f
or a quick and eas
y
r
efer
ence to k
eep in y
our pur
se or w
allet.
✂
✂