Viking F20021C - Manual (Page 6)

11 10
Service Information
If your warming drawer should fail to operate:
1. Have you read and followed the instructions provided?
2. Is the circuit breaker open, or is a fuse blown?
If service is required:
1. Call your dealer or authorized service agency. The name
of the authorized service agency can be obtained from
the dealer or distributor in your area.
2. Have the following information readily available:
a. Model number
b. Serial number
c. Date purchased
d. Name of dealer from whom purchased
3. Clearly describe the problem that you are having.
If you are unable to obtain the name of an authorized service
agency, or if you continue to have service problems, contact
Viking Range Corporation at (662) 451-4133 or write to:
VIKING RANGE CORPORATION
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi (MS) 38930 USA
Record the information indicated below. You will need it if
service is ever required. The model and serial number for your
warming drawer are located on the left side of the drawer
housing on an identification label. Pull out drawer for access.
Model Number Serial Number
Date of Purchase Date Installed
Dealer’s Name
Address
If service requires installation of parts, use only authorized parts
to ensure protection under the warranty.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
Material Cleaning Products Directions
Stainless Steel / Mild cleaners Sponge with cloth, then rinse
Enamels with clear water and wipe dry.
Satisfactory for use on all
finishes.
Plastic (Control Knob) Soap and water Pull off knob. Wash, but do
not soak. Rinse with water,
dry and replace on control.
CLEANING CHART
CAUTION
Do not use any cleaning agent with chlorine or chlorine compounds
on stainless steel finish. Chlorine and chlorine compounds are
corrosive to stainless steel.
When cleaning hard water spots and scales, use a vinegar and water
solution. Swab or wipe with cloth. Rinse with clear water and dry. If
the spots remain after using vinegar and water, a soft, non-abrasive
cleaner can be used. Apply with damp sponge or cloth. Satisfactory
for use on all finishes if rubbing is light. Always rub in the direction
of the polish lines.