VXI BlueParrott B200 User Manual

VXI Wireless Headsets

Advertising
background image

BASIC OPERATION

Charge headset in base for 4 hours
before first use. The multifunction
button on the headset will turn green
when fully charged. After use, this light
will turn red. It is not necessary for the
light to turn green to use the headset.

Microphone Adjustment: To ensure
proper microphone performance, do the
following.

1. The microphone has

the word TALK or a dot
printed or embossed
on it (under the
cushion). This mark
must face your mouth.

2. For quality sound and effective

background noise cancellation, position
microphone a finger’s width away from
your face just below your bottom lip.
The microphone is sensitive, minor
adjustments may be needed to achieve
optimum voice quality.

Standby/Talk Time Mod

es:

The headset

is in standby mode whenever you see a
slow-flashing yellow light on the headset
and the handset icon is lit on the front
of the base. If the headset icon is lit,
then the headset is active and Talk Time
is being used (even if you are not on a call).

Installation A

For phones without headset ports

BLUEPARROTT B200

Controls & Components

Standby/Pairing indicator lights

Volume decrease

Volume increase / Microphone mute

Multifunction button / Indicator lights

Pairing button

The headset battery charges

continuously while the

headset is in the base.

Headset active indicator light

Handset active

indicator light

Microphone volume adjustment

(located under base)

USE T-CORD

Installation B

For phones with headset ports

(Cisco phones see Installation C)

1. Leave handset plugged into your phone.

2. Plug short end of T-cord into headset
port on phone.

3. Plug longer end of T-cord into port on B200
base marked “Phone” . Thread cord under
hook.

4. Plug AC adapter into port on B200 base
marked and then plug AC adapter into
the wall electrical outlet.

USE T-CORD

Installation C

For Cisco models 7940 or higher

with a headset port

USE PATCH CORD

1. Leave handset plugged into your phone.

2. Plug the blue-banded end of the patch cord
into the headset port on your phone.

3. Plug other end of the patch cord into port
on the B200 base marked “Phone” .
Thread cord under hook.

4. Plug AC adapter into port on B200 base
marked and then plug AC adapter into the
wall electrical outlet.

1. Remove handset cord from phone’s base.

2. Plug short end of T-cord into now empty
handset port on phone.

3. Plug longer end of T-cord into port on B200
base marked “Phone” . Thread cord under
hook.

4. Plug handset cord into port on T-cord.

5. Plug AC adapter into port on B200 base
marked and then plug AC adapter into
the wall electrical outlet.

T-cord

Patch cord

Cord wraps

AC adapter

201956B_B200QuickGuide.qxd 12/15/2005 10:39 AM Page 1

Advertising