Viper 5301 - Manual (Page 25)

17 © 2011 Directed Electronics. All rights reserved.
Placing the system into the remote pair mode:
1. Turn the ignition to the On position.
2. Press, release, then press and hold the Control button (on the Control
Center).
3. The Control Center LED begins to flash and the horn honks once to
confirm the system is in Pair mode, the Control button can be released.
The system will stay in Pair mode for 60 seconds or until the ignition is
turned off. The horn will emit one short and one long honk when it exits
remote pair mode.
Placing the remote into the remote pair mode:
1. Press and hold the button for 8 seconds. If the transmit LED flashes at
3 seconds, disregard and continue to hold.
2. Wait for the Transmit LED to light solid. Release the button.
3. Press the
AUX
AUX button for 1 second. The transmit LED flashes 3 times.
4. Within 5 seconds, press the button.
5. The vehicle horn honks. You have now successfully learned the remote to
the vehicle remote start system.
6. Press the button two times to exit learn routine on the remote. The
transmit LED turns off and exit.
➢
Multi-car control capability
You can use the Responder LE 2- way and 1- way companion remote control
system for two cars, with full command capability for both vehicles.
While holding a command button and transmitting, the amber LED at the
top of the remote control flashes in groups to indicate which car is being
controlled.
• Car 1: 1 flash
• Car 2: 2 flashes