VXI BlueParrott TalkPro B1000-GTX - Manual (Page 10)

19
18
(consult your phone’s user manual). There may be a delay of a few seconds while the
headset and the handset discover each other. Dial as usual.
4. To end the call, press the multifunction button on the headset for 1 second. You
will hear a beep and the headset will disconnect from the call. Press the End/Off but-
ton on your cellular phone.
Answer A Call / End A Call
Before answering, make sure the headset is on (page 15).
1. Put the headset on and position the microphone properly.
2. Put the headset in Talk Time mode* by pressing the multifunction button for 1 sec-
ond and then releasing it. You will hear a single beep. Base unit will indicate green LED.
*If the yellow indicator light on the headset is flashing quickly, about once per second,
then the headset is already in Talk Time mode and you may proceed to step 3.
3. Activate your phone. You may need to select the Bluetooth headset menu option
(consult your phone’s user manual). There may be a delay of a few seconds while the
headset and the handset discover each other.
4. To end the call, press the multifunction button on the headset for 1 second.
You will hear a beep and the headset will disconnect from the call. Press the
End/Off button on your cellular phone.
Switch From Headset To Handset While On A Call
1. If you hear the low battery indication (page 11) you will need to immediately access
the appropriate menu on your phone to end the connection to the headset and
resume the call on the handset. For assistance, consult your phone’s user guide.
Switch From Handset To Headset While On A Call
Before switching, make sure the headset is on (page 15).
USING THE B1000-GTX HEADSET WITH A CELLULAR PHONE
Pair the B1000-GTX Headset With A Bluetooth Cellular Phone
You must pair the B1000-GTX headset to your Bluetooth cellular phone before
first use. See compatibility section of this user guide for phone compatibility infor-
mation.
1. Keep all other Bluetooth products at least 50 feet away or turn them off.
2. Make sure the headset is out of the B1000-GTX base and turned off (page 15)
3. Place the B1000-GTX headset and the Bluetooth cell phone no more than 3 feet apart.
4. Press and hold down the the multifunction button on the B1000-GTX headset for
about 5-10 seconds until you hear two series of melodic tones (hold it up to your
ear). The yellow and red indicator lights on the headset will flash alternately.
Release the multifunction button.
5. Refer to your phone’s user manual for pairing instructions.
The phone’s pass code must be set to 0000.
4. When the red indicator light on the B1000-GTX headset stops flashing, pairing has
been completed (check phone’s user manual for pairing confirmation indicators).
Make A Call / End A Call
Before you begin, make sure the headset is on (page 15).
1. Put the headset on and position the microphone properly (page 16).
2. Put the headset in Talk Time mode* by pressing the multifunction button for 1 sec-
ond and then releasing it. You will hear a single beep. Base unit will indicate a green
LED. *If yellow indicator light on the headset is flashing quickly, about once per sec-
ond, then the headset is already in Talk Time mode and you may proceed to step 3.
3. Activate your phone. You may need to select the Bluetooth headset menu option