VXI BlueParrott TalkPro B1000-GTX - Manual (Page 11)

21
20
REESTABLISHING THE CONNECTION BETWEEN THE B1000-GTX
BASE AND B1000-GTX HEADSET
Pair the B1000-GTX Base With The B1000-GTX Headset
If you use another manufacturer’s Bluetooth product with the B1000-GTX, you will
need to pair the B1000-GTX headset and base together again as follows.
1. Be sure the headset is off the base and that both are turned off (page 15).
2. Turn off all other Bluetooth products or keep them at least 50 feet away.
3. Position the B1000-GTX base and B1000-GTX headset no more than 3 feet apart.
4. Press and hold down the pairing button on the B1000-GTX base for approximately
5 to 10 seconds. The yellow light will flash, followed by the red and yellow indica-
tor lights flashing alternately. Release the pairing button.
4. Press and hold down the the multifunction button on the B1000-GTX headset for
about 5-10 seconds until you hear two series of melodic tones (hold it up to your
ear). The yellow and red indicator lights on the headset will flash alternately.
Release the multifunction button.
5. The red light will stop flashing on both the headset and the base. The yellow will
continue. Successful pairing has been completed.
1. Access the appropriate menu on your phone to activate the connection to the headset.
2. Firmly press the multifunction button on the headset for 1 second, then release.
3. Resume your conversation using the headset.
USING THE B1000-GTX BASE WITH A DIFFERENT BLUETOOTH
HEADSET
Pair The B1000-GTX Base With A Different Bluetooth Headset
You will need to pair the units together before first use as follows.
1. Make sure the B1000-GTX headset is out of the base and both are turned off (page 15).
2. Position the B1000-GTX base and your alternate headset no more than 3 feet apart.
3. Press and hold down the pairing button on the B1000-GTX base for approximately
5 to 10 seconds. The yellow light will flash, followed by the red and yellow indica-
tor lights flashing alternately. Release the pairing button.
4. Follow the alternate headset’s user guide for putting the headset into pairing mode.
5. When the red light on the B1000-GTX base stops flashing, pairing has been com-
pleted (check your alternate headset user’s manual for pairing confirmation indica-
tors).
Note: You will need to reestablish pairing when you return to use the B1000-GTX
headset with the base again (See “Reestablishing the connection between the
B1000-GTX Base and Headset” on page 21).