ViewEra V140 - Manual (Page 8)

4. Setup
Electrical Connection
Please follow the instruction below to properly connect the LCD monitor
to external electrical source.
1. Connect the female-end of the power cable to the transformer. Connect
the male-end of the power cable to the wall outlet or extension cable.
2. Connect the cable from the other end of the transformer to the LCD
monitor located at the back near the VGA signal cable.
Signal Connection
1. Power off both the LCD monitor and PC system before connecting them.
2. Take out the VGA cable from the box, then connect it to the signal
connector at the back of the LCD monitor.
3. Connect the other end to the VGA connector on the back of the PC
system.
4. Please make sure the connections between the PC system unit and the
LCD monitor is strong and secure. Please don’ t forget to tighten the
screws on each connector end.
5. Now turn on both the PC system unit and the LCD monitor.
6. After you finish setting up the LCD monitor, please set the refresh rate to
75Hz.
7. After setting up the LCD monitor, please perform Auto Adjust in OSD so
that the LCD monitor will automatically set to optimum color display
each time.
* Please note: When you disconnect any power cable or signal cable, please
do not pull the cable by grabbing the cable body. Please grab the cable
connector itself whenever you try to pull the cable during disconnect.
Page 12
5. Viewing Angles
Tilting
For better viewing angle, you may tile the LCD monitor forwards (up to 10
degrees) or backwards (up to 25 degrees, 90 degrees for packing).
Down：10 o
Up：25
o
Page 13