VocoPro RECODE-1 - Manual (Page 7)

7
FCC Information cont.
Keep it in a safe place for future
reference.
2. Install your unit in a cool, dry,
clean place - away from windows,
heat sources, and too much
vibration, dust, moisture or cold.
Avoid sources of hum (transform-
ers, v motors). To prevent fire
or electrical shock, do not expose
to rain and water.
3. Do not operate the unit up side-
down.
4. Never open the cabinet. If a
foreign object drops into the set,
contact your dealer.
5. Place the unit in a location with
adequate air circulation. Do not
interfere with its proper ventila-
tion; this will cause the internal
temperature to rise and may
result in a failure.
6. Do not use force on switches,
knobs or cords. When moving
the unit, first turn the unit off.
Then gently disconnect the power
plug and the cords connecting to
other equipment. Never pull the
cord itself.
7. Do not attempt to clean the unit
with chemical solvents: this might
damage the finish. Use a clean,
dry cloth.
8. Be sure to read the “Trouble-
shooting” section on common
operating errors before conclud
ing that your unit is faulty.
9. This unit consumes a fair amount
of power even when the power
switch is turned off. We recom-
mend that you unplug the power
cord from the wall outlet if the
unit is not going to be used for a
long time. This will save electricity
and help prevent fire hazards. To
disconnect the cord, pull it out
by grasping the plug. Never pull
the cord itself.
10. To prevent lightning damage,
pull out the power cord and
remove the antenna cable
during an electrical storm.
11. The general digital signals may
interfere with other equipment
such as tuners or receivers.
Move the system farther away
from such equipment if interfer-
ence is observed.
NOTE.
Please check the copyright laws in
your country before recording from
records, compact discs, radio, etc.
Recording of copyrighted material
may infringe copyright laws.
Voltage Selector (General Model
Only)
Be sure to position the voltage
selector to match the voltage of your
local power lines before installing
the unit.
110V