ViewEra V191 Series - Manual (Page 5)

4

If the product does not operate normally when the operating
instructions are followed. Adjust only those controls that are
covered by the operating instructions. Improper adjustment of
other controls may result in damage and will often require
extensive work by a qualified technician.

If the product exhibits a distinct change in performance,
service may be required.
4. Power and extension cords
 Do not allow anything to rest on the power cord.

Do not locate this product where persons will walk over the cord.

Use the proper power cord with correct attachment plug type. If the
power source is 120V AC, use a power cord that has UL and C-UL
approvals. If the power source is a 240V AC supply, use the tandem
(T blade) type attachment plug with ground conductor power cord
that meets the respective European country’ s safety regulations,
such as VDE for Germany.

Do not over load wall outlets or power cords. Ensure that the total
of all units plugged into the wall outlet does not exceed 10 amperes.

Ensure that the total ampere ratings on all units plugged into the
extension cord is not above the cord’ s rating.

If the power supply cord, which came with your monitor, is to be
connected to the PC instead of the wall outlet, Use an UL/TUV
approved computers with receptacle rated 100~240V AC, 50/60Hz,
1.0A (minimum) only.
5. Environment
 Place the monitor on a flat and leveled surface.

Place the monitor in a well-ventilated place.

Keep the monitor away from overly hot, cold or humid places, places
directly under sunlight, dusty surroundings, equipment that generate
strong magnetic fields.
 Please adjust the frequency to 60 Hz after setting up the LCD monitor.
 Then push the OSD menu button and use the auto adjustment function to
find the best mode of your computer.