ViewEra V191 Series - Manual (Page 9)

8
3. Installation
Unpacking
Open the shipping carton and check the package contents.
If any items are missing or damaged, contact us immediately.
The package should include the following items:
- 15” / 17” / 19” TFT-LCD monitor
-Power cord
-AC/DC power adapter
-VGA cable
-Audio cable
-User's manual
Installing the Base
Follow these steps to install the base:
1. Turn the monitor down.
2. Assembly the base to the arm with screw.
3. Tighten the screw with a coin.
Installing the Monitor
This monitor is equipped with an auto sensing DC power adapter for voltage
ranges of 100-240VAC, 60/50Hz. Follow these steps to install the monitor:
1. Before you connect the cables, make sure that the monitor and the system
unit power switches are off.
2. Plug one end of the VGA cable or DVI cable to the monitor and the other
end to the video signal connector at the rear of the system. Tighten the two
screws on the cable connector.
3. Connect the AC/DC power cord to the DC jack.
4. Connect the power cable.