VocoPro VHF-3000 - Manual (Page 13)

12
If you will be using the VHF-3000 with stage monitors and/or P.A. system, try the following:
• Place the stage monitor directly behind the microphone.
• Locate the P.A. loudspeakers so that they point away from the rear of the microphone. (With the speakers located
in these positions, the possibility of feedback is greatly reduced).
• Always check the stage setup before a performance to ensure optimum placement of microphone and monitors.
IMPORTANT: Every wireless microphone installation is a unique situation, and can present a variety of problems. Never
attempt a live performance without first conducting a “walkthrough” test of the system in the performing area. If major
changes (additional wireless systems or intercoms, relocation of scenery, etc.) have been made since the last walk-
through test, check the wireless system again, as close to performance time as possible.
OPERATIONS
1. Press the POWER button on the VHF-3000 receiver’s front panel. The power LED on the receiver will be BLUE.
2. Adjust the receiver’s VOLUME controls to approximately 50%.
3. Switch the microphone’s POWER BUTTONS to the ON positions.
4. Talk or sing into the microphones. During normal operation, the RF/AF signal LED’s will light RED when a
microphone is being used.
5. Adjust the receiver’s VOLUME controls until the output levels are balanced with eachother and other possible
source output i.e. CD+G tracks.
P.A. S peakers Facing Away
From Rear of M icrophone
M onit or D irectl y Behind
M icrophone
Operations