VocoPro VHF-3000 - Manual (Page 8)

7
Before starting any installation procedures, it is recommend that you completely unpack all the package contents.
The original packaging should be kept in the event that re-shipping is needed. Upon unpacking the VHF-3000, you
should have received the following items:
VHF-3000 receiver (1)
Handheld microphones (2) 3 ft. male/male ¼” cable (1)
Mounting brackets (1 pair) 9 volt alkaline batteries (2)
AC power adapter (1)
Mounting the VHF-3000
The included mounting brackets enable the VHF-3000 to be securley mounted into a 19” rackcase.
1. Attach mounting brackets to the VHF-3000 via the supplied mounting screws.
2. Align the VHF-3000 with the desired space in the rack and slowly slide in, rear panel first.
NOTE: Depending on your rack case design, it may be necessary to allow for sufficient space for the antennas.
3. While aligned, use rack case screws (not included) in the order shown below to stabilize the VHF-3000 in its
space, using the “X” rotation (numbered below) will ensure even tension and plush alignment.
NOTE: Do not tighten screws firmly until all screws are in place.
Getting Started
Mounting
1
3
1
2
4
Brackets
1
3
1
2
4