VTech SkillStarter Notebook - Manual (Page 7)

2
GETTING STARTED
Locate the 3 “AA” sized batteries on the back of your
SkillStarter™ Notebook. Remove the red tab so the
information you input will be saved.
CONNECTING THE MOUSE
1. Make sure the unit is OFF.
2. Locate the mouse jack on the right side of the unit.
3. Plug the mouse into the mouse jack.
CONNECTING THE PRINTER
1. Make sure both the SkillStarter™ Notebook and the VTech® VT-41 printer (sold
separately) are turned OFF.
2. Locate the printer port on the left side of the SkillStarter™ Notebook.
3. Connect the printer plug to the printer port.
4. Turn on SkillStarterr™ Notebook and the printer.
NOTE: Only the VTech® VT-41 printer is compatible with SkillStarter™ Notebook.
POWER SOURCE
SkillStarter™ Handheld operates on 3 “AA” size batteries (UM-3/LR6) or a VTech® 9V
adaptor (sold separately).
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit and open it.
3. Insert 3 new "AA" batteries (UM-3/LR6) as illustrated.
4. Close the battery cover.
NOTE: Replace with new, alkaline batteries.
RECHARGEABLE BATTERIES ARE NOT RECOMMENDED.
Standard for battery toys
• Do not try to recharge non-rechargeable batteries;
• Rechargeable batteries are to be removed from the toy before being charged;
• Rechargeable batteries are only to be charged under adult supervision;
• Do not mix different types of batteries; Do not mix new and used batteries;
• Only use batteries of the recommended or equivalent type;
• Always insert batteries properly matching the plus (+) and minus (-) signs;
• Batteries that have run out of energy must be removed from the toy;
• Do not short circuit the supply terminals;
• Do not use more batteries than recommended;
• Remove batteries from toy if it will not be used for an extended period of time.
48000MU 4/26/02, 1:45 AM 2