VTech SkillStarter Notebook - Manual (Page 8)

3
DC ADAPTOR
Use a VTech® adaptor or any other standard adaptor that complies with EN61558 DC 9V
300mA center-positive adaptor.
Connection
1. Make sure the unit is OFF.
2. Locate the adaptor jack on the left side of the unit.
3. Insert the adaptor plug into the unit’s adaptor jack.
4. Plug the adaptor into a wall outlet.
5. Turn the unit ON.
NOTE: If the unit stops working or the sound seems weak, it may be the result of the
adaptor connection. Turn the unit OFF and unplug the adaptor for 15 seconds.
Next, plug the adaptor back in and turn the unit ON. If the problem persists, it
may be the result of the adaptor's wiring or something may be wrong with the
unit.
Standard for adaptor toys
• The toy is not intended for use by children under 3 years old;
• Only use the recommended adaptor with the toy;
• The adaptor is not a toy;
• Never clean a plugged-in toy with liquid;
• Never use more than 1 adaptor;
• Do not leave plugged-in for extended periods of time.
Notice to parents
Regularly examine the adaptor, checking for damage to the cord, plug, transformer or
other parts. Do not use the adaptor if there is any damage to it.
BACKUP BATTERY INSTALLATION
Your SkillStarter™ Notebook comes with a backup battery already installed. Before
using the unit, remove the protective strip from the backup battery by pulling out the
plastic tab. To avoid damage to the unit from leaky batteries, replace the backup battery
at least once a year.
To replace the backup battery:
1. Make sure the unit is OFF.
2. Locate the backup battery cover on the bottom of the unit.
3. Using a screwdriver, loosen the screw of the battery cover.
4. Insert 1 CR2032 battery as illustrated.
5. Close the battery cover and tighten the screw to secure the battery
cover.
48000MU 4/26/02, 1:45 AM 3