Vector AIRPRO VEC258 User Manual

Page 7

Advertising
background image

12

11. BATTERY DISPOSAL

Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be

disposed of properly. Most states require recycling-contact your local municipal

authority for information.

Non-spillable, sealed, lead-acid battery, must be recycled or disposed of properly.

Recycling is required - contact your local authority for information. DISPOSAL

QUESTIONS FOR USA CALL toll free (877)288-7722.

WARNINGS:

• Do not dispose of the battery pack in fire as this may result in an explosion.

• Before disposing of the battery pack, protect exposed terminals with heavy-duty

electrical tape to prevent shorting (shorting can result in injury or fire). Failure to

comply with local, state and federal regulations can result in fines, or imprisonment.

12. SPECIFICATIONS

FOR COMPRESSOR:

Battery . . . . . . . . . . .12 volt, 3 Amp Hour, Non-spillable Sealed Lead-Acid

Compressor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .260 PSI Maximum

Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.82 lbs (.90 kg)

Height w/battery . . . . . . . . . . . . . . . . . . . . . . . . .11.25 inches (28.57 cm)

Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.0 inches (10.16 cm)

Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 inches (17.78 cm)

LANTERN LIGHT:

Quartz Halogen Bulb . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15W, G4

Fluorescent Tube . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .F4T5/D

11

4. Push the pins the new bulb into the socket and make sure the bulb is fully inserted.

5. Replace the lens and bezel.

6. Tighten (clockwise) the bezel until it is snug.

7. Test the light for proper operation by turning it ON and then OFF.

8.3

FLUORESCENT LAMP REPLACEMENT

The bulb type is a standard 4 watt F4T5/D fluorescent tube type. A replacement bulb

can be purchased from local lighting, hardware or camping stores. The fluorescent lamp

tube can be replaced after the front vertical lens is removed. The procedure follows:

1. Remove the battery pack or DC adapter. Using a small Phillips screwdriver,

unscrew (counterclockwise) the small screw at the top of the lens.

2. Slide the lens down from the top of the unit. The lens will come off. Set the lens aside.

3. Remove the fluorescent tube by turning one-quarter turn so pins at both ends of

the tube are released from the sockets. The tube will come out.

4. Set the defective tube aside for proper disposal.

5. Put in a new tube, being careful to keep the bulb pins from bending.

6. Rotate the tube one-quarter turn to lock the pins into the sockets.

7. Check the new tube to make sure it is secure in the sockets.

8. Replace the lens, and slide it towards the top of the unit. The screw holes should

align.

9. Replace the small screw and carefully tighten with the Phillips screwdriver.

10. Follow local ordinances for fluorescent bulb disposal and discard the old bulb.

9. MAINTENANCE/REPLACEMENT

PARTS

For replacement parts (batteries, DC power adapters, AC charging adapters, cables,

etc.), contact Vector technical support: (954) 584-4446 or toll free at (866) 584-5504.

Periodically, cables, hose, nozzles, and connectors should be inspected for damage,

corrosion, dust; and dirt. If surfaces are dirty, they can be wiped clean with a cloth

moistened with water and a drop of detergent. Battery pack contacts can be wiped

clean with a dry cloth.

10. BATTERY REPLACEMENT

The battery in the battery pack should be replaced with a new one when the operating

capacity is reduced to about one half or the ability to inflate one and one half

average sized automobile tires. Make sure that the battery is fully charged before

determining that the battery pack should be replaced. Contact Vector technical

support and ask for part VEC194. This battery pack is also used with other Vector

products that include portable inflators and spotlights. For more details, please contact

our technical support department toll free at (866) 584-5504.

VEC258 Manual 3/03.qxp 1/23/07 5:18 PM Page 11

Advertising