Velocity Micro SPK-VELO-001 - Manual (Page 4)

P.6
5. Your speakers are now portable and can be carried freely from room to
room, without disruption. Should you encounter any sound distortion
(signal cuts off or carries distortion), press the speaker’s “AUTO TUNE” button to
maximize the best reception.
If you hear interference from other components, switch on the channel control of
transmitter, and then move the speakers to another location. You can re-adjust
the tuning control by changing it to either channel 1 or 2 on the transmitter and
by then pressing the "AUTO TUNE" button, for best reception.
When transmitting / receiving over long distances, the signal from the system
will become weaker.
6. Switching Off
a) To protect the transmitter and save power, the transmitter will cut out
automatically if it detects that the unit is not being operated or, there is
weak reception from the signal audio source, for 4 minutes.
In other words, if the signal comes back, the transmitter will work again
automatically.
b) Press the ON/OFF button to turn off the speakers and the LED light will
P.7
then turn off, or simply press the ON/OFF button on the remote control unit.
If you use the remote control unit to turn off the speakers, the speakers
will be at stand-by mode for 5 minutes and the LED will change from blue
to yellow. You can switch on the speakers again by using the remote
control unit during the stand-by time. If there is no signal from the remote
control unit in 5 minutes, the speakers will automatically power off.
WARNING:
The Power adapters are for indoor use only. If it is wet outside or raining, you
can continue to operate your speakers via batteries. Please move the adapters out
of the rain by removing them and placing them in a safe dry place.
This device must be used with the AC/DC adapters supplied within the
package.