Vivotek IP7130 - Manual (Page 7)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
User's Manual - 7
Network Deployment
Setting up the Network Camera over the Internet
This section explains how to configure the Network Camera over an Internet connection �
1. If you have external devices such as sensors and alarms, make the connection from the
general I/O terminal block.
2� Connect the camera to a switch via Ethernet cable�
3� Connect the supplied power cable from the Network Camera to a power outlet�
There are several ways to set up the Network Camera over the Internet � The first way is to set
up the Network Camera behind a router � The second way is to utilize a static IP � The third way is
to use PPPoE �
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow
the steps below�
1. Connect your Network Camera behind a router, the Internet environment is illustrated below.
Regarding how to obtain your IP address, please refer to Software Installation on page 10 for
details�
IP address : 192.168.0.3
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
LAN (Local Area Network)
Router IP address : 192.168.0.1
WAN (Wide Area Network )
Router IP address : from ISP
Cable or DSL Modem
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5
Internet
1
2
3
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5 Ethernet Switch
1:Power +12V
2:Digital output
3:Digital input
4:Ground