Volvo S60 - Manual (Page 292)

07 Wheels and tires
Changing a wheel
07
292
WARNING
• The jack must correctly engage the jack
attachment.
• Be sure the jack is on a firm, level, non-
slippery surface.
• Never allow any part of your body to be
extended under a vehicle supported by
a jack.
• Use the jack intended for the vehicle
when changing a tire. For any other job,
use stands to support the vehicle.
• Apply the parking brake and put the
gear selector in the Park (P) position.
• Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
• The jack should be kept well-greased
and clean, and should not be damaged.
• No objects should be placed between
the base of jack and the ground, or
between the jack and the attachment
bar on the vehicle.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten hand-
tight. Using the lug wrench, tighten cross-
wise until all nuts are snug.
4. Lower the vehicle to the ground and alter-
nately tighten the bolts crosswise to
103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable).
The opening in the wheel cover for the tire's
inflation valve must be positioned over the
valve.