VocoPro UHF-5900 - Manual (Page 8)

8
Getting Connected
Connecting Power
1. Ensure the main power switch on the rear panel is set to OFF.
2. Connect the power adapter to the power input on the rear panel.
3. Plug the power adapter into a power outlet, or a surge protector.
NOTE: A surge protector is recommended to protect your equipment from power surges.
Connecting Audio
Using the XLR outputs
The XLR outputs allow you to connect each microphone channel separately to a mixer. This gives you more control over the
sound of the individual channels when they are connected to your mixer.
You will need:
• UHF-5900
• 4 XLR patch cables (not included)
• An input device, such as a mixer or amplifi er
To Connect the XLR outputs:
1. Ensure the main power switch on the rear
panel is turned off.
2. Connect one end of an XLR cable to the
channel 1 output of the UHF-5900.
3. Connect the other end of the XLR cable to
the desired input on your mixer.
NOTE: To avoid confusion, it’s recommended
that you plug channel 1 to input 1, channel
2 to input 2, and so forth. The illustrated
setup is for visual clarity only.
4. Repeat steps 2 and 3 until all the XLR
outputs are connected.
Using the 1/4” mixed output
The 1/4” mixed output is useful if you do not have a mixer, or if you have limited inputs available on your mixer. All four
microphone signals are mixed together in this output.
You will need:
• UHF-5900
• 1/4” patch cable
• An input device, such as a mixer or amplifi er
To Connect the 1/4” output:
1. Ensure the main power switch on the rear
panel is turned off.
2. Connect one end of an 1/4” cable to the
1/4” mixed output on the rear panel of the
UHF-5900.
3. Connect the other end of the 1/4” cable to
the desired input on your mixer or amplifi er.
�����
����� ������
��������
��������� ��������� ��������� ���������
������� �����
��������
SERIAL NO:
�������������������
�����
�����
�����
������
��������
��������� ��������� ��������� ���������
������� �����
��������
SERIAL NO:
�������������������
�����