VocoPro UHF-5900 - Manual (Page 9)

9
Connecting Antennas
The Antennas receive the UHF wireless signals from the microphones.
1. Attach the antennas to the connectors on the front panel by twisting them clockwise until fi rmly attached.
2. To disconnect the antennas, twist counter-clockwise.
Attaching the Rack Brackets
The UHF-5900 comes with detachable rack brackets which allows the unit to be installed in a standard 19 inch rack.
1. Use the included screws to fasten the rack brackets to the sides of the UHF-5900 as shown in the illustration below.
Mounting the UHF-5900 in a Rack
The UHF-5900 will fi t in a standard 19” rack (not included).
1. Align the UHF-5900 with the desired space in rack and slowly slide in, rear panel fi rst.
NOTE: Depending on your rack case design, it may be necessary to allow for suffi cient space for the antennas.
2. While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-5900 in its space,
using the “X” rotation (numbered below) will ensure even tension and fl ush alignment.
NOTE: Do not tighten screws fi rmly until all screws are in place.
��
���
���
����
�������� �����������������������
�������������������
��
���
���
����
�������� �����������������������
�������������������
Getting Connected
�
�
�
�