Viking Built-In Convection Microwave Hood - Manual (Page 40)

40
remove the filter. Repeat for the other
filter.
2. Soak the filters in a sink or dish pan
filled with hot water and detergent.
DO NOT use ammonia or other alkali;
they will react with the filter material
and darken it.
3. Agitate and scrub with a brush to re-
move embedded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into
the opening.
FAN
The fan will automatically start when heat rises from the cooking surface
and when convection, high mix, low mix or the broil settings are used. This
protects the microwave oven from excessive temperature rise. The fan will
stay on until the temperature decreases. It cannot be turned off manually
during this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave cooking surface unattended while using high temperatures.
Automatic fan may start and provide excessive air to the surface units. This
may cause spattering or boilover.
2. Avoid burning food.
3. Keep grease filters clean.
LIGHT
1. To replace light bulbs, first discon-
nect power to the microwave oven
at the circuit breaker panel or by
unplugging.
2. To release cover remove the screw
on the light cover. (See illustra-
tion.)
3. Replace bulbs with only 20 watt and
40 watt bulbs. These are available
at most hardware stores or lighting
centers. The unit will be shipped
with one 20 watt bulb and one 40
watt bulb. DO NOT USE A BULB
LARGER THAN 40 WATTS.
Light cover
Screw
Light
bulbs
Ring
Filter