VocoPro CDG-6000RV - Manual (Page 11)

10
Getting Connected cont.
Connecting an External Effects or EQ Device to the CDG-6000RV
The CDG-6000RV has EFFECT LOOP INPUT and OUTPUT jacks that can be used to add additional effects to
the audio signal which is sent to the speakers.
1. Remove the EFFECT LOOP BARS and store them in a safe place.
2. Connect an L/R RCA cable from the EFFECT LOOP OUTPUT on the CDG-6000RV rear panel to the
INPUT jack on the External Effects or EQ device.
3. Connect an L/R RCA cable from the OUTPUT of the EXTERNAL EFFECTS or EQ DEVICE to the EFFECT
LOOP INPUT on the CDG-6000RV rear panel.
�����������������������������
�� ���