VIEWSONIC PJD6251 - Manual (Page 28)

EN-25
Network Control
This feature provides the ability to remotely control and manage the projector through
the network.
Preparation:
1. Connect one end of the internet cable to the Network Control connector on the
projector.
2. Connect the other end of the internet cable to an available RJ-45 connector on
your computer.
3. Turn on your projector and computer.
There are two ways to connect to the network control:
A. Auto IP address setting (DHCP : Yes):
1.
Enable DHCP from the projector OSD, under Network Config.
„ When DHCP is enabled, IP Address, Subnet Mask and Gateway
information will get from DHCP server automatically.