Vivitar DP-1200 X - Manual (Page 35)

EN-34
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual
Projector
Replacing the Lamp
The projector lamp used for the light source has a certain life. It is time to replace them
lamp when:
When lamp dims, the projected image gets darker or starts to deteriorate.
The projector lamp LED indicator turns to red (See page 16).
Caution:
The lamp becomes a high temperature after turning off the projector with the
power button. If you touch the lamp, you may scald your finger. When you
replace the lamp, wait for at least an hour for the lamp to cool. Be sure to turn off
the projector and unplug the power cord before replacing the lamp.
1.Turn off the projector and unplug the power cable.
2.Turn the projector over so you can access the lamp cover.
3. Remove the access panel screws and open the panel.
4. Remove the screws on the bottom of the lamp assembly.
5. Grasp the lamp handle and pull the lamp assembly directly out of the projector.
6. Replace with the new lamp.
7. Place back the screws on the bottom of lamp assembly.
8. Place the panel and screw back the screws on the lamp cover.
Note:
Be sure not to touch the optical surfaces with your fingers.
Lint-free gloves or finger cots are recommended.
Do not put your hands into the lamp replacement spot,
or not fall any liquid or object into it to avoid
electrical shock or fire.
Be sure to turn off the projector and unplug the
power cord before replacing the lamp.