VARTA V-AVD99 - Manual (Page 23)

V-AVD99
23
Loading a disc
Press EJECT button on the panel to flip it down. Insert the disc with the printed side facing upward into the
slot. Close the panel. The disc will be loaded and played automatically. If the unit is in another mode, press
MODE button on the RC or SRC button on the unit to select DISC mode.
Press EJECT button on the panel to eject the disc.
Inserting a SD/MMC card/USB device
Insert the MMC/SD card into the corresponding slot on the top of the panel and insert USB device into the USB
jack on the panel. The unit will automatically switch to the needed mode.
If a USB driver is connected to the unit, the unit cannot switch to SD/MMC reading mode automatically when
you insert a SD/MMC card, except after taking out the USB. If the unit is reading the files in the SD/MMC
card, the unit cannot switch to USB reading mode automatically when you connect a USB driver, except after
taking out the SD/MMC card.
Note: Some USB driver models cannot be supported by this unit.
Playing/pausing
When the disc/card/USB has been loaded, the playback of the first track starts automatically. To ensure good
system performance, wait until the unit finishes reading the disc information before proceeding. Or press the
PLAY/PAUSE/AMS button on the RC or PLAY/PAUSE button on the panel to start playback. Press it again to
pause the playback. Press again to resume the playback.
Stop playback
During playback, press STOP button on the RC. Playback will be stopped.
For DVD discs: If PLAY/PAUSE/AMS button on the RC is pressed or PLAY/PAUSE button on the panel,
playback will start from the position at which it was stopped. If the disc is removed, the resume function is
cancelled. Press STOP button on the RC again to finally stop the playback.