VIEWSONIC PJ650/PJ520 - Manual (Page 17)

Turning On The Power
Precautions
Connect all devices to be used to the projector prior to turning on the power.
WARNING: When the power is ON, a strong light is emitted. Do not look into the lens.
1 Make sure that the power cord is firmly and correctly connected to the projector and outlet.
2 Turn on the projector's power
Set the power switch to [ | ] (ON). The projector will go to STANDBY mode and the POWER indicator
will light to solid orange.
3 Press the STANDBY/ON button (control panel or remote
control)
• The projector begins warming up and the POWER indicator
blinks green.
• The POWER indicator stops blinking and
lights to solid green once the projector's
power is completely on.
4 Remove the lens cap
The picture is projected.
NOTE:
Turn the power on/off in right order.
•
Power on the projector before the computer or video tape recorder.
• Power off the projector after the computer or video tape recorder.
POWER indicator
power switch
Control panel
ViewSonic PJ650/PJ520 14