Vivitek DVR5612 - Manual (Page 20)


How to use OSD
8
Before use OSD, You must know:
Recommended ways to learn about operations
Before starting, please follow the suggested steps to understand the fundamentals of operating the display,
and then you will be able to learn the operations in a short time:
1.Please first learn to power on and power off the display. Refer to page 18 for the descriptions of the
operations.
2.Please learn how to operate the OSD.
3.Understand what each OSD menu is. Refer to page 20~28 for an explanation of the
OSD contents.
Example how to select correct input signal source.
After power on the display, first step: you need to select the correct input signal source. The screen will be
blank without any images with incorrect input signal source. Follow the steps to set up:
1.Use OSD to select the correct input source, press the
MENU
key and bring up the OSD menu.
2.Use ▲▼ keys to select the “INPUT SETUP” option , press OK to enter the submenu.
Press
OK
to enter the Submenu
3.Then the OSD will show the Submenu as below:
Follow the OSD's indicate to operate the OSD.
For example:
.Use
▲▼
key to select the item "Main Input" , "PIP
INPUT" or "INPUT SIGNAL"
2.then use
OK
to enter the item that you select.
eg: use
▲▼
to select MAIN INPUT, press
ok
then use
◄ ► to select input source TV, DTV....
3.If you want to exit the submenu, press
EXIT
on remote
control to main menu or Menu key to exit OSD.
4.Press
OK
, then press
◄ ► to change
the main input source, last press
OK
again to
exit this main input setup.
5.Now you understand:
Just to press the
MENU key to show the OSD
And follow the OSD buttom line's information to operat the OSD. So you only need
MENU, EXIT , OK,
▲▼ ◄► , ENTER
these keys to control the whole OSD.
If you still have any question, please call our service center to help you.
Quick Input Source select way
For Main Input
Press the
INPUT
key in the front control panel or remote control repeatedly, the input signal mode will appear on
the top left corner, please select correct input signal mode.(Refer to Input relative page 13~15,24) COMP
For PIP Input
Please refer to page 24.