Vivitek DVR5612 - Manual (Page 29)

28
SPECIAL FEATURE
1.OSD H POSITION
Use ◄►to move OSD horizontal position.
2.OSD V POSITION
Use ◄►to move OSD vertical position.
3.OSD TIMEOUT
Use◄►to set up OSD display time, the value range is
5 seconds to 4 seconds.
After press the
MENU key, the
OSD will appear.
If the OSD TIMEOUT
is set to 0 seconds,
OSD screen will
automatically
disappear in 0
seconds if not any
key is pressed.
4.LANGUAGE
Set OSD display language, there are three language
options:
ENGLISH
FRANÇAIS
ESPAÑOL
5.SYSTEM INFO
Display some information about the display, may also
be displayed by pressing the hotkey INFO on the
remote control.
♦ MODEL NUMBER
Show the display’s model number
♦ MAIN INPUT
Display the input signal of current main picture
♦ WIDE FORMAT (MAIN)
Display main picture’s aspect ratio (Refer to page 25)
♦ PIP INPUT
Display the input signal of current main picture
♦ LAMP TIME
Display the time the lamp has consumed.
♦ SOFTWARE VERSION
Display the display’s software version
6.RESET ALL SETTING
Select YES to return all OSD settings to the defult
values, the LAMP timer and OSD display language will
not be affected. Select NO to stay unchanged.
7.RESET LAMP TIMER
Select YES to set the time lamp consumed to zero.
Select NO to stay unchanged.
When installing a new lamp, be sure to set
the LAMP TIMER to zero. This ensures correct
display of the time consumed by the lamp.
8.SLEEP TIMER
=remote control key "SLEEP"
Set up the time to turn off the display, works the same
as the hotkey SLEEP on the remote control. The sleep
timer will be reset to zero every time when the display
restarts. If it is set to 0 minutes, this means in 0
minutes from the timer is set, the display will be turned
off automatically. If the timer is set to OFF, the function
will be disabled.
8
How to use OSD