Wolf Appliance Company M I C R O W AV E O V E N - Manual (Page 10)

10
U N PA C K I N G Y O U R M I C R O W A V E
Remove all packing materials from inside
the oven cavity; however,
Do not remove
the waveguide cover, which is located on
the right cavity wall, see illustration below.
Read enclosures and save this Use and
Care Information for future reference.
Remove the feature sticker (if there is one),
from the outside of the door.
Check the oven for any damage, such as
misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose
door hinges and latches and dents inside
the cavity or on the door. If there is any
damage, do not operate the oven and
contact your dealer or Wolf authorized
service center.
W O L F M I C R O W A V E O V E N I N S TA L L AT I O N
C H O O S I N G A L O C A T I O N
F R E E - S T A N D I N G
You will use the oven frequently so plan its
location for ease of use. It’s wise, if possible,
to have counter space on at least one side of
the oven. Allow at least two inches on the
sides, top and at the rear of the oven for air
circulation.
B U I L T- I N
Your microwave oven can be built into a
cabinet or wall by itself or above a Wolf 30"
(762) wall oven. Refer to the installation
instructions in both the wall oven and Wolf’s
Microwave Trim Kit. The trim kit includes finish
trim strips, ducts, installation instructions and
information on the location of the power
supply. To request the trim kit, contact your
dealer. Be sure to check the local building
code, as it may require the opening be
enclosed with sides, ceiling and rear partition.
The proper functioning of the oven does not
require the enclosure.
Safety
door
latches
Hinges
Door seals and sealing surfaces
Waveguide cover