Weider PRO XT75 - Manual (Page 6)

1.
Press four 60mm Square Outer Caps (28) onto the
ends of the Right and Left Bases (1, 3).
Attach the Right and Left Bases (1, 3) to the Center
Base (2) using four M10 x 78mm Bolts (33) and
four M10 Nylon Locknuts (31).
Do not tighten the
Nylon Locknuts yet.
6
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight rack can be assembled success-
fully by anyone. However, it is important to real-
ize that the versatile weight rack has many parts
and that the assembly process will take time.
Most people find that by setting aside plenty of
time, assembly will go smoothly.
ASSEMBLY
Before beginning assembly, make sure you
understand the information in the box above.
Important: Some of the parts described in the
assembly steps may be pre-assembled. 1
1
28
28
28
28
33
33
31
31
3
2
2. Press a 60mm Square Outer Cap (28) onto the end
of the Weight Guide Base (4).
Attach the Foot Plate (5) and the Weight Guide
Base (4) to the Center Base (2), as shown, using
two M10 x 78mm Bolts (33) and two M10 Nylon
Locknuts (31).
Do not tighten the Nylon Locknuts
yet.
2
2
28
33
5
4
31
31