Weider PRO XT75 - Manual (Page 7)

7
4
5a 5b
5. Refer to drawing 5a. Press six Square Bushings
(21) into the Right Weight Rest (19) and the Right
Weight Spotter (20) as shown. Pull out the
Adjustment Knobs (22) and slide the Right Weight
Spotter and the Right Weight Rest down over the
right Uprights (7, 8) as indicated.
Refer to drawing 5b. Secure the Right Weight
Spotter (20) and the Right Weight Rest (19) to the
right Uprights (7, 8) by tightening each of the three
Adjustment Knobs (22) into an adjustment hole in
the Uprights.
Assemble the Left Weight Spotter (not shown) and
Left Weight Rest (not shown) on the left Uprights
(7, 8) in the same manner.
Make sure both Weight
Spotters and both Weight Rests are at the same
height.
3
1
33
31
31
21
21
22
22
7
7
8
8
22
22
20
20
19
19
6
6
7
8
29
4. Tap a 60mm Square Inner Cap (29) into each of the
Front Uprights (7).
Attach one of the Front Uprights (7) and two Joint
Plates (6) to the Left Base (3) using four M10 x
78mm Bolts (33) and four M10 Nylon Locknuts (31).
Make sure the Front Upright is oriented so the
holes near the bottom of the Front Upright and
the holes in the Joint Plates line up. If they do
not line up, turn the Front Upright upside-down.
Do not tighten the Nylon Locknuts yet. Make
sure the Front Upright is turned so the adjust-
ment holes are facing the Rear Upright (8) and
the number decals on the Front Uprights are fac-
ing each other.
Attach the other Front Upright (7, not shown) and
two Joint Plates (6, not shown) to the Right Base
(1) in the same manner.
21
3
1
33
31
3
8
Adjustment
Holes
8
3. Identify the two Rear Uprights (8), which are slightly
shorter than the Front Uprights (not shown).
Attach the Rear Uprights to the Right and Left
Bases (1, 3) using four M10 x 78mm Bolts (33) and
four M10 Nylon Locknuts (31).
Do not tighten the
Nylon Locknuts yet. Make sure that the Uprights
are oriented exactly as shown, with the adjust-
ment holes on the indicated side near the bottom.