Winegard RD-4610 - Manual (Page 3)

FIGURE 2
(4) 5/16-18 x 5/8"
Flat Head Bolt
(4) 5/16" Flat Washer
(4) 5/16-18 Hex Nut
Backup Assembly
RS-1000 Antenna
Reflector
STEP 3. Attach reflector to backup assembly as shown in Figure 2.
STEP 4. Attach RS-1000 antenna to elevating tubes, see Figure 2, using the two Eclips
and pins provided. Attach coax cable to F-jack on antenna, slide weather boot over
boot collar.
Attach coax cable to
F-jack on antenna,
slide weather boot
over boot collar.
Attach RS-1000 to
elevating tubes using
E-clips and pins
supplied.
Rev. 2/98
NOTE: Make sure that
coax cables fits between
the reflector and the fixed
feed arm.
ANTENNA SHOWN PARTIALLY RAISED
FOR EASE OF ILLUSTRATION ONLY
3