Wasp Bar Code WWS850 - Manual (Page 17)

29
Update
• Fixed Code Length Qualification
Select Fixed Length Qualification
Fixed Length 1 *
Fixed Length 2 *
Programming Instructions: (1) Read the label. (2) Program the desired length
by reading Decimal Digits on page 53. (3) Read the “Validate” label (also on
page 53) to complete this setting.
Matrix 25 Parameters Matrix 25 Parameters Matrix 25 Parameters Matrix 25 Parameters
• Start / Stop Selection
Industrial 25
Interleave 25
< Matrix 25 >
• Checksum Verification
Enable
< Disable >
• Checksum Transmission
< Enable >
Disable
30
Enter Setup
• Max / Min Code Length Qualification
Select Max / Min Length Qualification
Max Length *
Min Length *
• Fixed Code Length Qualification
Select Fixed Length Qualification
Fixed Length 1 *
Fixed Length 2 *
Programming Instructions: (1) Read the label. (2) Program the desired length by
reading Decimal Digits on page 53. (3) Read the “Validate” label (also on page
53) to complete this setting.
Codabar Parameters Codabar Parameters Codabar Parameters Codabar Parameters
• CLSI Conversion
Enable
< Disable >
• Start / Stop Transmission
Enable
< Disable >