weber 2200 Series - Manual (Page 5)

5
Step 6
Install Lid
Remove hinge pins and hair pin cotters from back of
cooking box.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair
pin cotters into the small holes in the hinge pins.
Figure 9.
Remove tape securing the thermometer into its holder.
Hair pin cotter
Hinge pin
Step 7
Install Weber Warm-Up Basket
Insert one end of the Weber Warm-Up Basket into the
hole in the right end of the lid and the other end into the
slot in the left end of the lid. Figure 10.
Figure 9
Figure 10
Step 5
Remove grill from lower packaging
Make sure natural gas hose is free from lower
packaging before lifting.
WARNING: Lifting the barbecue from the lower
packaging requires at least two people.
With two people lift straight up and over lower packaging
and cardboard support.
Figure 8
Step 8
Remove control panel
Remove the right side work table. Remove the burner
control knobs. Figure 11 (a). Grasp the under the edge
of the control panel at the control panel push-in buttons
and slide along the frame toward you. Figure 11 (b). Lift
off the control panel.
Figure 11
(a)
(b)
control panel push-in
buttons