Whistler GPS - Manual (Page 29)

Routes
The Galileo ™ can store 20 routes with up to 30 waypoints each.
Routes can be followed either from the Map Page or on the
Compass Page.
Note: The routes screen will not have any routes listed if this
is the first time using this screen. See 27-A.
Important: Waypoints must be programmed before making
routes. Remember, the Galileo ™ does not provide turn-by-turn
navigation; it’s strictly “as the bird flies.” An “*” next to a route
name indicates that the route’s navigation is turned on. The
Routes menu consists of: New, Edit, Delete, Delete All, Set
Navi and Cancel Navi (Navi = Navigation).
Note: Only a total of 500 waypoints can be used for routes.
Enter a Route:
1. With the Direction Button, select “Routes” from the Main
Menu, and press the OK Button. The routes screen will be
displayed. See 27-A. If routes were previously entered it
will show the names of these routes and the waypoints for
each route listed. See 27-B.
2. Press Menu and select New by pressing the OK Button.
This is the only option if no routes have been entered.
3. A default route name “R001” is displayed. The next route
name will be R002 etc. You can change the name or add a
comment at any time. See Waypoint section for editing the
name and comment fields.
4. Press Menu and select “Add WP” by pressing the OK Button.
This is the only option if no waypoints have been entered.
5. Move the Direction Button until all waypoints are
highlighted and press the OK Button. See 27-D.
6. Select first waypoint to go to and press the OK Button.
Number “1” will be displayed next to the waypoint selected.
7. Repeat step 6 for the remaining waypoints for the route.
See 27-C.
8. Press the PAGE/ESC Button, then select the “Check” box
and press the OK Button. If finished, press the OK Button
again. This returns you to the routes screen.
9. Press the PAGE/ESC Button to exit the routes name screen.
Routes
GALILEO ™ GPS
27
Routes
27-A
27-B
27-C
27-D