Weider 9300 PRO - Manual (Page 16)

16
35. Wrap the Press Cable (87) around a 3 1/2Ó
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the bracket on the Press Base
(13) closest to the Press Upright (4) with a
3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut
(42). Be sure that the Cable Trap is turned
to hold the Cable in place.
36. Wrap the Press Cable (87) around a 3 1/2Ó
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the other bracket on the Press
Base (13) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó
Nylon Locknut (42). Be sure that the Cable
Trap is turned to hold the Cable in place.
37. Attach the end of the Press Cable (87) to the
Large ÒUÓ Bracket (83) with a 1/4Ó Washer
(37) and a 1/4Ó Nylon Locknut (44). Do not
completely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable so only a couple of threads are
showing above the Nylon Locknut, as
shown in the inset drawing.
38. Identify the High Cable (84)Ñthis is the
shortest remaining Cable. Wrap the High
Cable around a 3 1/2Ó Pulley (82). Attach the
Pulley to the Top Frame (2) with a 3/8Ó x 3
3/4Ó Bolt (76), a 3/8Ó Washer (38), and a 3/8Ó
Nylon Locknut (42).
Wrap the High Cable (84) around another 3
1/2Ó Pulley (82). Attach the Pulley and a
Cable Trap (80) to the Top Frame (2) with a
3/8Ó x 3 3/4Ó Bolt (76), a 3/8Ó Washer (38),
and a 3/8Ó Nylon Jam Nut (43). Be sure that
the Cable Trap is positioned to hold the
Cable in place.
35
36
37
CABLE ASSEMBL
Y
87
42
4
50
13
13
82
80
83
87
80
87 82
50
42
87 83
37 44
84
80
38
38
42
76
76
2
82 82
43
38
37
44