Western Digital Studio Edition II - Manual (Page 13)

MY BOOK STUDIO EDITION II
USER MANUAL
SETTING UP – 10
eSATA
Note: The eSATA interface does not support WD Drive Manager
1. Turn on your computer and wait for the operating system to load.
2. Insert the software CD into the CD-ROM drive.
3. Double-click the CD-ROM drive icon.
4. Double-click the WD Drive Manager folder, which contains the software for this
device
5. If you want to install the backup software now, double-click the WD Anywhere
Backup icon in the My Book Studio Edition II screen and follow the instructions as
prompted.
6. Turn off your computer.
7. Connect the adapter’s DC cable plug to the DC power input at the rear panel of
the product. Verify that plug type of your wall power adapter is the correct plug
type for your region.
8. Connect the wall adapter to your AC power receptacle.
9. Plug one end of the eSATA cable into an available port on your computer.
10. Plug the other end of the interface cable into the device.
11. Turn on your computer.
12. Turn on My Book by pressing the power button located on the back panel.
13. The unit will power up and mount to the system. Your My Book Studio Edition II is
now installed and ready to use.
Note: Some eSATA controllers may require a system reboot to recognize the device.
1 2
Power Off