Wizcom Quicktionary 3 Lite - Manual (Page 4)

Getting Started
4
The Pen Power Supply
The Pen comes with 2 AAA Alkaline batteries.
Safety Points (Batteries)
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Use
AAA Alkaline batteries only.
• Always place 2 fresh batteries in the Pen. It is not advisable
to use the Pen with batteries that are not at the same voltage
level.
• Do not combine different types of batteries (e.g. rechargeable
and non-rechargeable).
• Dispose of used batteries according to the manufacturer's
instructions.
Preserving Battery Usage
To optimize battery usage, go to Set Auto Shut-Off Time in Preferences in
the Pen Main Menu and modify the settings according to your needs.
Unpacking the Pen
To get started:
1. Remove the Pen from the protective case.
2. Lift the battery cover on the back of the Pen by pushing the
tab down and out.
3. Insert the batteries into your Pen with the positive and
negative terminals corresponding to the markings on the
sides of the battery compartment.
4. Close the battery compartment.
5. Turn the Pen on by pressing the red Power key.
The Pen is ready to scan!