Wolf Induction s ICBCT30IU - Manual (Page 17)

17
W O L F I N D U C T I O N C O O K TO P U S E & C A R E
To change the heat setting—the element is
activated and the power bar indicator graph
remains steadily lit:
Touch ”+” to increase the heat setting by
preset one or two bars on the power bar
graph.
Touch ”–” to decrease the heat setting by
preset one or two bars on the power bar
graph.
Touch to increase the heat setting
directly to high.
Touch to boost to Hi-Power mode.
Touch or to decrease the
heat setting directly to the lowest power.
Touch to turn the element off.
IMPORTANT NOTE: If no cookware or an
incompatible pan is placed on an induction
element after activating the element, the
control will blink for 30 seconds, then the
element will automatically shut off.
IMPORTANT NOTE: To quickly de-energize all
induction elements, use the universal
touch pad located in the lower area of the
control panel. Refer to the illustration below.
The illustrations below show the control panel
of Model ICBCT36I/S.
C O O K TO P O P E R AT I O N
To activate an induction element, touch the
touch pad that corresponds to the
element you wish to use. The power bar
indicator graph will begin to blink and show
8 LED indicator bars. Refer to the illustrations
below.
To complete the activation, touch one of the
following symbols or touch pads of the
element control while the bar graph is still
blinking:
Touch the ”+” or ”–” symbol to set the heat
output to 25% and complete the activation.
Touch to set the power output to
the high heat setting and complete the acti-
vation.
Touch or to set the power
output to the lowest heat setting and
complete the
activation.
Touch to set the power output to
the maximum level and complete the acti-
vation.
Heat settings Induction element activation Universal OFF touch pad
Universal
touch pad
touch pad
touch pad
touch pad
Power bar
indicator graph
”+” and ”–”
symbols