Weider 831.159301 - Manual (Page 8)

8
7. Identify the Right Arm (48) and the Left Arm (47)
by the position of the welded bracket on each Arm.
Wet the end of the Left Arm (47) with soapy water
and slide a Large Pad (45) onto it. Make sure the
Butterfly Arm Plastic Bushing (74) is in the Arm.
Lubricate both axles on the Top Frame (55). Have
another person slide the Left Arm (47) onto the
left axle on the Top Frame.
Note: Make sure not
to confuse the Right Arm (48) with the Left
Arm. Make sure that the upper end of the Left
Arm is behind the indicated bracket on the
Top Frame.
Set two 25mm Retainers (69) on top of a 25mm
Round Cover Cap (70).
Make sure that the teeth
on the Retainers bend toward the Cover Cap,
as shown in the inset drawing. Tap the
Retainers and Cap onto the left axle on the Top
Frame (55).
Attach the Right Arm (48) in the same manner.
8. During steps 8 through 19, see the CABLE
DIAGRAMS on page 17 of this manual to verify
proper cable routing.
Locate the Short Cable (58). Lay the Cable in
the bracket on the Base (4) and under the Press
Frame (17). Attach a 90mm Pulley (15) to the
bracket with an M10 x 48mm Bolt (12) and an
M10 Nylon Locknut (21).
Make sure that the end
of the Cable with the ball is on the indicated
side of the bracket.
9. Route the Short Cable (58) under a 90mm Pulley
(15) Attach the Pulley and a Cable Trap (66) to
the lower hole in the Front Upright (42) with an
M10 x 95mm Bolt (71), an M10 Washer (9), and
an M10 Nylon Locknut (21).
Make sure that the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
8
9
47
70
69
74
48
55
Bracket
Lubricate
Axle
15
17
21
12
4
Bracket
21
58
58
42
15
66
71
9
45
7
69
55
70
Cable Assembly