Weider WEBE09310 - Manual (Page 10)

10
ATTACHING WEIGHTS TO THE LEG LEVER
To use the the Leg Lever (9), slide the desired amount
of weight (not included) onto the weight tube on the Leg
Lever.
WARNING:
Do not place more than
50 pounds on the Leg Lever (9).
9
Weight
Tube
ADJUSTING THE WEIGHT RESTS
To change the height of the Weight Rests (6), remove
your barbell from the Weight Rests. Then, remove
the Adjustment Knobs (27) from both Uprights (4, 5).
Position the Weight Rests at the desired height, so that
the holes in the Weight Rests and the Uprights are
aligned. Fully tighten the Adjustment Knobs into the
Weight Rests and the Uprights.
WARNING:
Always set both Weight
Rests (6) at the same height. The Adjustment
Knobs (27) must be inserted through the Weight
Rests and the Uprights (4, 5) and be firmly tight-
ened. Never tighten an Adjustment Knob into an
Upright before inserting the Weight Rest.
6
6
27
27
5
4
ATTACHING THE CURL POST
For some exercises, the Curl Post (13) must be
attached to the weight bench.
Insert the Curl Post (13) into the indicated hole in the
Front Leg (2). Align the holes in the Front Leg and the
Curl Post. Secure the Curl Post with an Adjustment
Knob (27).
Make sure that you fully tighten the
Adjustment Knob.
27
13
2