Weider WESY49201 - Manual (Page 13)

13
24. See the inset drawing. Attach a 3 1/2” Pulley
(15) and a Cable Trap (66) to the upper hole in
a Long “U”-Bracket (57) with a 3/8” x 2” Bolt
(12) and a 3/8” Nylon Locknut (21). Be sure
that the Cable Trap is inside the Long “U”-
Bracket. Note: This may come pre-assem-
bled.
Route the High Cable (58) through the Long
“U”-Bracket (57) and around the 3 1/2” Pulley
(15) shown in the inset drawing. Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
25. Wrap the High Cable (58) around a 3 1/2”
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with a 3/8” x 2” Bolt (12)
and a 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and
that the Cable and Pulley move smoothly.
26. Note: This assembly step shows how to
complete the assembly of several pre-
attached parts.
The 5/8” x 9/16” Spacer (7) has been pre-
attached on the outside of the 3 1/2” Low
Pulley (102) for shipping purposes. Remove
the 3/8” Nylon Locknut (21), the Spacer, and
the Pulley from the 3/8” x 3 3/4” Bolt (88). Do
not remove the Bolt. The Bolt has been
shown removed for part identification.
Reattach the 3 1/2” Low Pulley (102), with the
5/8” x 9/16” Spacer (7) between the Pulley and
the Press Frame (17). Do not tighten the 3/8”
Nylon Locknut (21) yet. Be sure that the
3/8” x 3 3/4” Bolt (88), the 3/8” Washer (9),
the 5/8” x 9/16” Spacer, the 3 1/2” Low
Pulley, and the 3/8” Nylon Locknut (21) are
oriented as shown.
24
58
15
15
66
21
12
57
Bracket
55
21
12
15
58
25
26
CABLE
ASSEMBL
Y
58
57
21
17
102
7
9
88