Weider WESY49201 - Manual (Page 18)

18
38. Locate the Leg Press Cable (99). Attach the
end of the Leg Press Cable to the Long “U”-
Bracket (57) with a 1/4” Nylon Locknut (2) and
a 1/4” Washer (10). Do not completely tight-
en the Nylon Locknut. It should be thread-
ed onto the end of the Cable only a couple
of turns, as shown in the inset drawing.
Wrap the Leg Press Cable (99) around a
3 1/2” Pulley (15). Attach the Pulley to the Leg
Press Upright (56) with the 3/8” x 3 3/4” Bolt
(88), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). The ball on the Cable must be
on the indicated side of the Pulley. Be sure
that the Cable and Pulley move smoothly
and that the Cable is between the Pulley
and the welded rod.
39. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 5/16” x 3” Bolt (111)
and a 5/16” Nylon Locknut (3).
Wrap the Leg Press Cable (99) around a 3 1/2”
Pulley (15). Attach the Pulley to the Press
Bracket (94) with the 3/8” x 2” Bolt (12) and a
3/8” Nylon Locknut (21).
Slide a 5/16” Washer (8) onto a 5/16” x 2 3/4”
Bolt (11). Insert the Bolt through the lowest
hole in the Rear Seat Frame (100) from the
indicated side. Note: The three holes are for
cable adjustment. Tighten a 5/16” Nylon
Jamnut (93) onto the Bolt. Slide the end of
the Leg Press Cable (99) onto the end of the
Bolt. Thread another 5/16” Nylon Jamnut onto
the Bolt. Do not fully tighten the second
Jamnut. There must be room between the
two Jamnuts for the end of the Cable to
pivot.
39
CABLE
ASSEMBL
Y
11
111
96
94
12
21
100
93
8
3
99
15
38
56
57
Ball
9
21
15
2
88
2
10
57
99
99
Welded
Rod
10