Weider WEBE34100 - Manual (Page 14)

14
USING THE WEIGHT RESTS AND SAFETY
SPOTTERS
Before beginning an exercise, move the Weight Rests
(19) and the Safety Spotters (20) to sets of holes in the
uprights that are best suited for that exercise. The
selected holes for the Safety Spotters should represent
the lowest point to which you want the barbell to go dur-
ing the exercise. The selected holes for the Weight
Rests should be at a comfortable height for lifting and
replacing the barbell. Perform the exercise as shown in
the accompanying Exercise Guide. Note: Make sure
the Adjustment Knobs (22) are fully tightened.
WARNING:
Always set both Weight
Rests (19) at the same height and both Safety
Spotters (20) at the same height.
19
19
19 20
20
22
This section explains how to adjust the weight bench. See the Exercise Guidelines on page 17 for important
information about how to get the most benefit from your exercise program. Also, refer to the accompanying exer-
cise poster to see the correct form for each exercise.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The
weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
Adjusting the Weight Bench
SETTING UP THE BENCH FOR SQUAT EXERCISES
Squat exercises should be performed inside the rack
(behind the dotted line in the picture). When performing
squat exercises, set the Weight Rests (19) and the
Safety Spotters (20) at a comfortable height, and move
the bench away from the rack.
Squat
Area
20
WARNING:
Always move the bench
when you are performing squat exercises inside
the rack.