Wolfgang Puck IBC1000 - Manual (Page 4)

7
Helpful Hints
• The hand blender can be used in hot liquids, up to 240°F. Always
use care when using in hot liquids. To avoid splashing when using
the hand blender in a saucepan, insert the hand blender into the
pan first, and then press the ON/OFF switch for operation.
• Do not allow the blender to touch the bottom of a hot saucepan.
• To puree foods, a certain amount of liquid is needed. Add cooking
liquid, broth, juice, milk, or cream, until desired consistency is
reached.
• This appliance is not intended to chop ice. Add ice to beverage
after blending.
• This appliance is not intended to beat egg whites.
• For thorough blending, move blade up and down in mixture until
smooth.
• You will achieve better mixing results if you use deep, tall
containers.
• For easy cleanup, unplug blender and rinse under running water
immediately after using.
• Place liquid ingredients into the beaker first unless recipe specifi-
cally states otherwise.
• Before turning the appliance on, immerse the hand blender
attachment into the prepared ingredients, thus ensuring they will
not spill over.
• For greater efficiency, move the appliance in small outward
spiraling circles while mixing, without touching the bottom of the
beaker with the hand blender attachment.
• The hand blender attachment cannot blend hard or fibrous ingre-
dients unless they are in less than 1/4 - 1/2” pieces, soft ones into
1/2 - 1” pieces.
• Some foods require a small amount of liquid to allow them to
move freely around the blades. Soft or wetter foods require less
liquid, while dry ingredients require more liquid. Add the liquid a
little at a time until the mix gains the required consistency.
• When using the hand blender, ensure the blades are covered to
avoid splashing.
6
Assembly and Use of
FFoooodd C Chhooppppeerr Attachment
1. Ensure the motor base is unplugged.
2. Assemble chopper bowl by first placing the
chopping blade onto the blade shaft in the
chopper bowl. Then place food in bowl. For best
results, solid foods should be no larger than 1/4”
or 1/2" cubes.
3. Secure the bowl cover firmly onto the bowl by
turning clockwise.
4. Attach motor base to top of bowl cover by
turning clockwise.
5. Plug into 120-volt 60 Hz AC only outlet.
6. Hold the motor base with one hand and
the bowl with the other. Set speed control
to MAX. Press the ON/OFF switch to
begin chopping. Use a pulse action when
chopping by pressing and releasing ON/OFF
switch .
This unit is equipped with a safety off
feature. Once you stop the
blender/chopper, you must press the
ON/OFF switch twice in order to restart.
7. Do not operate the motor continuously for more
than 15 seconds when using chopper
attachment. Allow it to cool off for 3 minutes
before next use.
8. When you are finished, simply release the ON/OFF
switch, unplug the motor base, and then unscrew the
chopper bowl.