Whirlpool ACC082XR0 - Manual (Page 11)

11
To change the temperature display from °F to °C:
1. Turn off the air conditioner.
2. While the air conditioner is off, press and hold down the
MODE and FAN SPEED buttons while pressing POWER to
turn on the air conditioner.
NOTE: Follow these same steps to change the temperature
display from °C to °F.
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Hour indicator
light will turn on, and display will show remaining hours
before air conditioner will turn off.
2. Press the plus or minus button to adjust the delay time (1 to
24 hours).
3. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Hour indicator light will turn off, and Room
indicator light will turn on. Display will show the current room
temperature.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Timer indicator light will flash. Hour indicator
light will turn on, and display will show remaining hours
before air conditioner will turn on.
3. Press the plus or minus button to change delay time (1 to
24 hours).
4. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Hour indicator light will turn off, and Room
indicator light will turn on. Display will show current room
temperature.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on air conditioner.
2. Adjust Mode to Auto, Cool, Fan Only, or Power Saver.
NOTE: For Auto mode, go to Step 4.
3. For Cool, Fan Only or Power Saver mode, adjust FAN SPEED
to Turbo, High or Low.
4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Timer indicator light will flash. Hour indicator
light will turn on, and display will show remaining hours
before air conditioner will turn on.
7. Press the plus or minus button to change delay time (1 to
24 hours).
8. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Hour indicator light will turn off, and Room
indicator light will turn on. Display will show current room
temperature.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Timer indicator light will
shut off.
To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Hour
indicator light will turn on, and display will show remaining
time.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.
3. After 10 seconds, Hour indicator light will turn off, and Room
indicator light will turn on. Display will show the current room
temperature.
Operate Air Conditioner with Remote Control
NOTE: Remote control may vary in appearance.
NOTE: Two AA batteries (not included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To turn the air conditioner on or off:
Press POWER.
To select the mode:
Press AUTO COOL, COOL, FAN ONLY, or POWER SAVER.
■ Auto Cool—fan speed is adjusted automatically.
■ Cool, Fan Only or Power Saver—you can adjust the fan
speed.