Whirlpool CGS365H - Manual (Page 28)

28
PROBLEM
The display is showing
“PF”
“F” followed by a
number shows on the
display
W
HEN SELF
-
CLEANING YOUR OVEN
PROBLEM
The Self-Cleaning cycle
will not work
CAUSE
• You did not press START/ENTER.
• The door is not closed all the way.
TROUBLESHOOTING
C
OOKING RESULTS
D
ISPLAY MESSAGES
CAUSE
If none of these items are causing your problem, see “Requesting Assistance or Service” on page 29.
• There has been a power failure. Press OFF/CANCEL to clear the display,
then reset the clock, if needed. (See page 10.)
• Press OFF/CANCEL to clear the display. If an “F” code appears again, call
for service. (See “If You Need Assistance or Service” on page 29.)
PROBLEM SOLUTION
Cookware not level
on cooktop • Level the range. (See the Installation Instructions.)
• Use cookware with a flat bottom.
Excessive heat on cooktop
in areas around cookware • Choose cookware the same size or slightly larger than the burner flame.
The oven temperature
seems too low or too high • Adjust the oven temperature control. (See “Adjusting the oven temperature
control” section.)
Slow baking or roasting
• Preheat oven to selected temperature before placing food in oven.
• Choose bakeware that will allow 2 inches of air space around all sides.
• Position rack higher in oven.
• Decrease oven temperature 15
°
to 25
°
F.
• Increase baking or roasting time.
• Increase temperature 25
°
F.
• Preheat oven to selected temperature before placing food in when
preheating is recommended.
• Choose bakeware that will allow 2 inches of air space around all sides.
• Open oven door to check food when timer signals shortest time suggested
in recipe.
• Oven peeking can make cooking times longer.
• Level the range.
• Bake in center of oven with 2 inches of space around each pan.
• Check to make sure batter is level in pan.
• Shield edge with foil.
Baked items too brown
on bottom
Unevenly baked items
Crust edge browns
before pie is done
(Check to see if liquids
are level in cookware)