Weider 831.153991 - Manual (Page 10)

10
9. Attach the Lat Tower (5) to the Upright (3) with
four 3/8” x 1” Screws (100) and four 3/8” Lock
Washers (74).
Plug the Upper Wire Harness (13) into the
Console (53).
Push all of the excess wire into
the Upright (3). Make sure the wire does not
get pinched. Attach the Console to the Upright
with two #8 x 1/2” Screws (82).
10. Attach two Eyebolts (51) to the Lat Tower
Crossbar (49) with two 5/16” Washers (76) and
two 5/16” Nylon Locknuts (107).
Attach the Lat Tower Crossbar (49) to the Lat
Tower (5) with two 3/8” x 2 1/2” Button Bolts (96),
two 3/8” SAE Washers (75), and the Crossbar
Cover (50).
Make sure that the Eyebolts (51)
are oriented as shown in the inset drawing. If
they are not, turn the Lat Tower Crossbar
around and reattach it.
11. Attach a Large Pulley (17) and the Pulley Plate
(18) to the Upright (3) with an M12 x 62mm
Button Bolt (80) and an M12 Nylon Locknut (72).
Do not tighten the Locknut yet.
5
100
100
74
3
82
82
53
13
74
9
49
50
75
107
76
76
51
51
96
5
3
80
17 18
72
10
11
51
49
5
Side View
107