Weider 831.153991 - Manual (Page 12)

12
18. Insert the rod on the Backrest Frame (36) into the
slot in the Seat Carriage (48). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
18
36
36
48
48
Rod
Slot
Rod
17
82
82
63
63
36
16. Hold a Large Pulley (17) inside of the upper cable
(B). Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (81) and an M12
Nylon Locknut (72).
Make sure that the cable is
routed as shown in the CABLE DIAGRAM on
page 18.
Screw two 3/8” x 1 1/2” Tension Screws (106) into
the two Pulley Brackets (10) a couple of turns.
Make sure the hexagonal holes in the Screws
are on the outside of the Brackets. Tighten the
two Screws an equal number of turns.
17. Attach the two Guard Plates (63) to the inside of
the Backrest Frame (36) with four #8 x 1/2”
Screws (82).
16
72
10
106
B
81
17
19. Locate the Leg Lever Cable (62), which has two
ends that are the same length and a third end
that is longer.
Route the longest end of the Leg Lever Cable
(62) through the hole in the Front Leg (31), and
attach it inside of the hole in the Leg Lever (32)
with a 3/8” x 2 1/2” Bolt (94), two 3/8” SAE
Washers (75), and a 3/8” Nylon Locknut (73).
19
62
62
32
32
94
73
75
75
31